Sound and light control switch how to install the sound and light control switch installation process

With the rapid development of science and technology, the switch is also continuing to develop intelligently. The sound and light control switch is one of the representative products. The so-called sound and light control switch refers to the light controlled by the volume and the illumination. When the ambient brightness of the room reaches the set value and the volume exceeds the set value, this type of switch will turn on. So how to install the sound and light control switch ? The following small series will introduce the detailed process of the sound and light control switch installation, hoping to help the needy friends.

Sound and light control switch how to install

1. In the past, most people used manual control switches, which were inconvenient to use. Nowadays, the switching technology has made great progress. Many people have installed sound and light control switches in corridors or warehouses. So how to install the sound and light control switch? First of all we need to use the power switch 220V, the maximum power of the switch is greater than the power of the light bulb, select the appropriate delay, there is to ensure quality, can be used for a long time.

2. After selecting the switch, the next step is to adjust the parameters. We first open the front cover of the switch, and then adjust the parameters of the light control and voice control. Under normal circumstances, everyone can adjust the light control to “twilight” and the voice control to “low” so that the switch can be used to the maximum extent. And don't waste electricity.

3, we adjust the appropriate parameters, then we take a look at the switch connection method. From the circuit diagram, we see that this switch has three wiring holes, they are the fire line, the zero line, the control line, the control line is usually only used by the company, the family connection is to connect the fire line and the zero line.

4. Next, let's take a look at how to connect the wires. Before connecting the wires, we should tear off the wire insulation cover by about 2 cm to expose the copper core, then connect the switching switch to the connection post, and then insert the copper core into the connection screw. The exposed copper core should not exceed 5cm. The lamp is connected to the zero line and it is the arrow in the switch. The live line is connected to L.

5. After everyone connects the line, the next step is to install the switch on the wall and prepare the switch box. Both the clear box and the cassette can be used. Tighten the screws around the switch, cover the cover, and adjust the angle to make the switch. Put it right, then you can power on the test.

These are related to share about how sound and light control switch installation procedure and detailed sound and light control switch installed, to be a reference! In order to ensure the safety of everyone before installing sound and light control switch, it is best to turn the power off to avoid An electric shock has occurred. If you have more related issues, welcome to continue to pay attention to this site, and later will bring more exciting content for everyone.